SERVICE MANUL
Model No.HLTD500AGW
Issue
Rev.
- 11 -
WRINKLE SAVER BUTTON
At the end of the cool down cycle,the dryer will periodically tumble for 1 hour to prevent
wrinkles from setting in your garments. Use this button to extend the feature for 150 minutes
or to turn the Wrinkle Saver feature off.
F
E
DRY TEMP BUTTON
Use this button to select a dryer temperature.For best results,follow your garment label
instructions garment label instructions and use the warmest temperature that is safe for
your fabric.
G
ESTIMATED TIME REMAINING DISPLAY
H
This display shows the estimated total time for a dry cycle in minutes.As the dryer operates,
the dryer operates, the minutes will count down to show the time remaining.
If the dryer senses a malfunction,an error code will be shown in the display. Please refer to the
“Troubleshooting” section for a list of error codes and their possible causes and solutions.
I
TIMED DRY ADJUST BUTTONS
Use these buttons to adjust the length of a timed dry cycle.Time can be adjusted from 10
to 95 in 5 minute increments.
J
CYCLE SIGNAL BUTTON
Use this button to adjust the volume of control panel beeps and the end-of-cycle signal.
Eco Dry -
Perm Press -
Delicate -
Use this cycle to save energy. The program is similar to Normal, but uses a slightly
lower temperature and dries to a slightly lower dry level.
Use this cycle for low-temperature heat and wrinkle-free fabrics.
Use this cycle for extra-low heat to gently dry delicate items.
Timed Dry -
Quick Dry -
Touch up -
Rack Dry -
There are 4 Timed Dry Cycles to choose from:
Use this cycle to run the dryer for a specifi c amount of time.
Clothes may be damp or could be over-dried at the end of the cycle.
Use this cycle to easily select a 20 minute timed cycle for quick
drying a few items.
Use this cycle to easily select a 10 minute timed cycle for
refreshing clean clothes.
Use this cycle to dry foam, rubber, plastic, or heat-sensitive fabrics.
START/PAUSE BUTTON
NOTE:
After starting a dry cycle, you must pause the dryer to change any of the options.
Press this button to start a selected cycle or to pause an operating cycle
NOTE:
Opening the dryer door will also pause an operating cycle.
NOTE:
If the cycle status is Wrinkle Saver, pressing the pause button or opening the dryer
door will cancel the operating cycle and turn the power off.
NOTE:
This button works with timed dry cycles only. The No Heat setting is not available
with an automatic cycle.
NOTE:
If the cycle status is Cool Down, the time cannot be adjusted.
