Haier HDBL865ATS, Installation Instructions Manual

Page: 5 / 36

3
YOU NEED TO:
•
Slowly open dishwasher door while someone grasps the rear of the
dishwasher. Remove the drain hose and lower rack. Close dishwasher
door until latched.
•
Install this dishwasher as specified in these instructions.
•
Installation should be performed by a qualified service technician. The
dishwasher must be installed to meet all electrical and plumbing national
and local codes and ordinances.
•
The dishwasher must be installed to allow for future removal from the
enclosure if service is required.
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
PARTS SUPPLIED
2 - #8 x 5/8” Phillips flat head
wood screws
2 - Side mounting clips 2 - Top mounting clips
Hose clamp Drain hose
PARTS NEEDED
Ferrule, compression nut
and 90° elbow with 3/8” N.P.T.
external threads on one end.
(The other end must fit your
water supply line).
Hand shut-off valve Thread seal tape
3 UL listed wire nuts Waste tee
(house plumbing, if applicable)
Electrical cable
(power cord, if applicable)