ENGLISH
INSTALLATION NOTES
1. Do not slide oven across floor. Damage to floor covering
or floor could result.
2. The oven support surface must be a minimum 3/4" (2cm)
thick plywood platform.
For single ovens, it must support 202 pounds.
The platform must be solid, level and flush with the bottom of
the cabinet cut out.
3. Use extreme caution when moving or installing the oven.
It is very heavy.
DO NOT LIFT THE OVEN BY THE DOOR HANDLE,
remove the door for easier handling and installing.
See REMOVING THE DOOR in the maintenance section
of the Operating Instructions.
4. Be very careful when moving or installing the oven to
avoid damage to the oven frame or damage to the cabinets.
5. Be sure to level the oven. An oven that is not level may
provide poor or inconsistent baking results.
6. Be careful when placing oven. DO NOT pinch the conduit
between the oven back.
WARNING
Before installing or removing, turn power OFF at the service
panel. Lock service panel to prevent power from being turned
ON accidentally.
Securely fasten oven to cabinet using the screws provided.
Failure to do so could result in oven moving or tipping
during use and causing damage to the oven or cabinets or
personal injury.
Know how to disconnect the power to the oven at the circuit
breaker or fuse box in case of an emergency.
CAUTION
Unit is heavy and requires at least two people or proper
equipment to move.
Ltr.
DIMENSION
A
Cutout Width
B
Cutout Depth
C
Cutout Height
D
E
Minimum Spacing
Electrical Ratings and Maximum Connected Load
TECHNICAL DATA
For cutout dimensions see following section titled:
Preparing location
SINGLE OVEN
Amperes
kW
Amperes
kW
@ 120V/240V 60Hz
@ 120V/208V 60Hz
SINGLE
30”
28 7/16”
(72
.
2 cm)
24”
(61 cm)
27 3/8”
(69
.
5 cm)
34”
(86
.
5 cm)
1/2”
(1
.
3 cm) min
Oven Position (distance from floor)
STEPS FOR INSTALLATION
The following pages provide the necessary information for
proper installation of the oven and are arranged as follows:
Technical Data
Installation Cutout Dimensions, Required Clearances and
Mounting instructions for:
- Under counter Installation, Single Oven
- Wall Installation, Single Oven
Electrical Supply and Wiring Requirements, Programming
required if connecting to
120V/
208V Circuit. Electrical
Connections for 3-wire or 4-wire Branch Circuit.
Final Checklist
CAUTION
Do not remodel the oven.
ENGLISH
WALL OR UNDER COUNTER INSTALLATION, SINGLE OVEN
・
Confirm the strength of the wall surface.
・
When the strength of the wall surface is weak,
give reinforcement.
CAUTION
HCW3460AES
16.1
3.79
17.8
3.64
4
ENGLISH
Installation Manual
