20
20
(1) Before installation
1) Before installation, check if the model, power supply, pipe, wires and parts purchased respectively are
correct.
2) Check if the indoors and outdoors can be combined as the following.
Outdoor
Indoor
Capacity (X 100W)
Indoor Qty
Total indoor capacity (X 100W)
AV08NMSETA
13
113~293
AV10NMSETA
16
140~364
AV12NMSETA
16
167~436
Air-conditioner can't be installed in the place with inflammable gas. Or it will cause fire
hazard.
The unit should be installed at the place where the cold/hot air or noise will not interfere
the neighbours.
The unit should be installed at the place with good ventilation. No obstacle at the air
inlet/outlet. And no strong wind blows the unit.
The installation space refers to the latter info.
The unit should be installed at the strong enough place. Or it will cause vibration and
noise.
The place where the water can flow fluently.
The place where no other heat source will affect the unit.
Pay attention to the snow against clogging the outdoor.
In installation, install the anti-vibration rubber between the unit and the bracket.
The unit is better not be installed at the below places, or it will cause damage.
The place where there is corrosive gas (spa area etc).
The place blowing salty air (seaside etc).
Exists the strong coal smoke.
The place with high humidity.
The place where there is device
emitting Hertzian waves.
The place where voltage
changes greatly.
(2)
Installation place selection