7
RESET MEMORY
To erase all transmitters from memory and to reset to the factory default configuration,
press and hold both the Set and Mode/Advance switches simultaneously for 2 seconds.
The display will show "EE". If you choose to continue, press and hold the Set and
Mode/Advance switches simultaneously for 2 seconds once again. Memory is reset at
the end of the two seconds.
NOTE:
If you choose not to reset memory at the "EE" display, don’t press any keys
for 10 seconds and the receiver will return to Run Mode.
CONNECTING TO OMNILT
Connect the receiver to the OmniLT controller using 4-conductor, 22-gauge or larger
wire as follows:
1.
Connect the "A" and "B" terminals of the 45A00-1 to the “YEL”
(Yellow) and “GRN” (Green) terminals under the section marked
“CONSOLE” on the OmniLT controller (Yellow = A and Green = B).
2.
Connect the "+12" and "GND" terminals of the 45A00-1 to the "RED"
and "BLK" (Black) terminals under the section marked “CONSOLE”
on the OmniLT controller (Red = +12V and Black = GND).