4
TYPE LED - In Setup Mode,
the Type LED (see Figure 2) is used to indicate if a
transmitter is supervised.
SETUP MODE
The Setup Mode is used to configure the general operating parameters of the receiver,
to program a transmitter into the receiver, and to change the characteristics of a
programmed transmitter. The Mode LED does not blink in Setup Mode.
To enter the Setup Mode:
A.
Press and hold the Mode/Advance switch for approximately two seconds.
B.
Press the Set switch to increment the value of a Setup item.
C.
Press the Mode/Advance switch is to advance to the next Setup item.
Receiver Address
You are first prompted to enter the receiver address. "A" is shown on the left of the
display and the current address is shown on the right. Press the Set switch to
increment the address value. The current address will be stored into memory when the
Mode/Advance switch is pressed. Setup Mode is exited when the Mode/Advance
switch is pressed and held for two seconds.
Number of Addresses
Next, you are prompted to enter the “number of addresses” (see the Setup information
in this document for configuration of each HAI controller). The letter "n" is shown
on the left of the display and the digit for the current number of addresses is shown on
the right of the display. Press the Set switch to increment the number of addresses
value. The current number of addresses will be stored into memory when the
Mode/Advance switch is pressed. Setup Mode is exited when the Mode/Advance
switch is pressed and held for two seconds.
Configuring Transmitters
All of the following locations are used for configuring and programming transmitters.
Each new transmitter can be programmed into the receiver and each programmed
transmitter, along with its characteristics, is displayed and can be modified. The
transmitter number is shown in the LED Display.