Be sure that all electrical
appliances and outlets are turned
off at the circuit breaker before
working in the cabinet area.
Please wear safety glasses to
protect eyes when drilling.
COLD
HOT
4 INSTALL FAUCET
5 INSTALL DRAIN CONNECTOR
NOTE: You will need a sink top hole between 11⁄2” and 1⅝” in diameter. If drilling a new
hole, ensure faucet body will mount flat against surface and that there is sufficient tubing
between faucet body and system manifold. Drilling holes into solid surfaces or surfaces
made of stone should only be performed by a qualified and certified installer.
1. Attach remaining ⅜” white tubing to stem on on faucet body. Wet tubing and insert into the
faucet stem-fitting approximately ⅝” or until it stops. Gently tug on the tubing to ensure it is
firmly seated in fitting.
NOTE: Do not connect ⅜” white tubing from tank to faucet.
2. Mount faucet base by pushing toggle bolts through the sink hole until faucet base is flush
with countertop. Position toggle bolts under sink surface being certain faucet stem will
not be obstructed. Loosely fasten faucet base to countertop by tightening toggle bolts,
alternating between left and right sides to tighten evenly. Leave loose to adjust faucet body
as desired.
3. Route the 3 tubes attached to faucet body through the faucet base and through hole in sink
until approximately 1” of tubing remains above sink.
4. To adjust faucet body handle to desired location, turn ¼ clockwise and hold faucet base
firmly, mount faucet body to faucet base.
5. Hold base firmly to keep it from moving while turning faucet body ¼ turn counterclockwise
and pull facuet body and tubing up. Then tighten faucet base by tightening toggle bolts
evenly. Make sure not to over tighten.
6. Return faucet body to faucet base; turn ¼ turn clockwise until it locks.
7. Attach faucet spout to faucet body by screwing spout nut to body.
1. Identify drain outlet location.
2. Remove protective cover from back of foam seal.
3. Knock center hole out, align holes, and attach to front plate of drain connector.
4. Allowing room for drilling, position the drain connector on sink drain pipe above drain trap.
5. Securely tighten nuts and screws.
6. Using drain connector port as drill guide, drill ⁷⁄32” hole through wall of drain pipe.
Be sure not to penetrate opposite side of pipe, and be careful not to damage side
of drain port fitting.
1
2
3
4
5
6
7
