2-2
SECTION 2 –
SAFETY AND PRECAUTIONS
•
Keep riders off machine. The only time a
passenger should be permitted to ride
inside the cab is for instructional or
diagnostic purposes only. The passenger
should be seated in the instructor seat
next to the operator and never allowed to
ride outside of the cab.
•
Ensure there is adequate clearance
before driving under any overhead
obstructions. Contact with power lines
may result in serious injury or death.
•
Booms must be folded and in cradles
when driving the machine on a roadway or
when near power lines.
Remove Paint Before Welding or
Heating
•
Avoid toxic fumes and dust. Hazardous
fumes can be generated when paint is
heated by welding, soldering, or using a
torch.
•
Do not use chlorinated solvents in areas
where welding will take place.
•
Perform all work in an area that is well
ventilated to carry toxic fumes and dust
away.
•
Dispose of paint and solvents properly.
Avoid Heating Near Pressurized
Lines
•
Avoid torching, welding, and soldering
near pressurized hydraulic lines.
Pressurized lines may accidentally burst
when heat goes beyond the immediate
flame area.
Handle Fuel Safely
•
Always turn the engine off and allow it to
cool before refueling.
•
NEVER smoke while refueling.
•
Do not fill tank completely, as fuel may
expand and run over.
•
Always clean up spilled fuel with soapy
water.
•
Keep a fire extinguisher nearby when
refueling.
Operate Safely ^
•
Before moving the machine, ensure there
are no obstacles or persons in the path of
travel.
•
Never operate a machine in the same field
as walking personnel.
Summary of Contents for STS 10
Page 290: ......
