hager RTS001X, Manual

Page: 20 / 52

User interface and button assignments
1. Accept calls
2. End call or reject incoming call
3. Actuate door opener relay
This button stores the DTMF sequence to control the door
opening relay (intercom options). This only works if a call
has been established
4. Actuate light relay
This button stores the DTMF sequence to control the light
relay (intercom options). This only works if a call has been
established.
5. Establish connection to door
The video stream assigned to the door to call must have
previously been defined (camera button 9-12).
6. Mute ringtone
Mutes the call signal. All other functions continue to run
normally.
7. Call settings menu
This button takes you to the Videofon settings.
8. Camera/door switching (i2BUS only)
On this button the DTMF sequence for camera/door switch-
ing in the i2BUS system is set up (intercom options). This
button only works in the i2BUS interface mode and in an
established call.
9. - 12. Other entrances and cameras
These buttons are assigned to entrances/door stations or
IP cameras/servers (Intercom options - Entrance/camera).
Pressing the button shows the video stream. A call to the
corresponding door can be made with the "Establish call to
door" button (5). With an entrance configured as an i2BUS
interface, the video image is displayed only after the call
is established, since the i2-BUS cameras are disabled in
the idle state and only activated after a door connection is
active.
13. Ending Videofon
Button can be converted to "minimize" in the settings to
protect against ending.
14. Minimize Videofon
Videofon is minimised. The application can be called again
from the Tasktray menu.
15. Display of registration status
This display shows you the registration status on the
RTD110X. Green = Videofon is registered.
Yellow = registration procedure is in progress.
Red = videophone is not registered.
RTS001X
User interface and other adaptations
20 Subject to technical changes www.hager.com
5
6
7
8
9
10
11
12
1
2
3
4
13 14
15