hager FB LE Series, Installation And Operating Manual

Page: 19 / 48

Assembly
Technical changes reserved 17
6 Assembly
Check the supplied mounting accessories to make sure that they are complete:
-
2 lugs
-
1 two-way key bit
-
10 countersunk screws 4.5x20
-
2 countersunk screws 6.0x120
-
6 short and 3 long strips of fire protection sealing
-
1 insertable air filter
Opening and closing the door(s)
Opening:

Insert the key into the lock.

Rotate the key a quarter of a turn clockwise and pull out the swivel lever.

Turn the swivel lever upwards by 180° anti-clockwise.

Open the door.
Closing:

Close the door, making sure that the swivel lever is in the open position.

Press the door lightly and turn the swivel lever downwards 180° clock-
wise.

Allow the swivel lever to snap into the swivel lever holder until you hear it
click into place.

Remove the key.
Note when removing the doors from the hinges

Pull the pin out of the hinges to remove the doors.
CAUTION
At least two people should always remove the door panels from the
hinges for safety reasons.
Protection type IP44
ATTENTION
Protection type IP44 is only achieved if the fire safety housing is
mounted on a suitable wall.
The wall and floor must meet fire resistance class F30 or F90.

If the fire safety housing is set up as a free-standing unit, an additional
rear panel must be installed. This must be ordered as an additional item.