hager FB LE Series, Installation And Operating Manual

Page: 6 / 48

For your safety
4 Technical changes reserved
Summary of important transport and storage information
-
Transport and storage conditions: -5°C to +40°C
-
Beware of the risk of tilting during transportation!
-
Only remove the protective film, protective corners or other packaging
material directly at the installation site!
-
Pay attention to the enclosed mounting material on the protective film or on
the housing!
-
Never transport the housing with the doors open!
-
Always have two people transport the housing!
-
If transporting the housing using a forklift, ensure the forks are long enough
for the dimensions.
-
Pay attention to any protruding parts.
-
If transporting the housing using a crane, do not walk under suspended
loads.
-
Notify us immediately of any damage.
-
The products must not be stored outdoors and must be protected against
moisture (water).
Basic information
-
Do not install damaged parts as this will immediately render the warranty and
proof of usability null and void.
-
The housing is not covered by the required building control usability
certificate if it is not assembled completely and properly.
-
Ensure compliance with building laws and guidelines, as well as instructions
from the relevant building authorities and the responsible fire protection
expert.
-
As the installer, you may only issue an unreserved manufacturer's declaration
in relation to compliance with building authority approval if the installation has
been completed in a compliant manner.
-
In the declaration, make a note of any deviations that are not minor.
-
Observe the relevant provisions of the VDE (Association for Electrical,
Electronic & Information Technologies).
-
Observe the requirements of the fire authorities.
-
Observe accident prevention guidelines and workplace guidelines.
-
Keep the opening range of the doors free at all times.
-
Unauthorised access to the housings is not permitted.
-
The doors of the fire safety housing must be kept closed when in operation.
-
Secure the housing to prevent it from tilting.
Installation conditions of fire safety housings
-
This product be mounted vertically and horizontally.
-
The surface underneath it must be even
-
Only suitable for indoor installation
-
The installation location must be frost-free and dry, with an ambient
temperature of -5°C to +35°C
-
Not suitable for outdoor installation
-
The floor/wall must be suitable (bearing capacity, classification,
fire-resistance class)
-
Carefully check the suitability of the wall properties for the heavy weight of
the housing prior to on-wall mounting of the fire safety housing
(FBxxLE/FBxxSE).
-
Check that the supplied dowels are suitable in relation to the wall properties.