8300 Low Energy Auto-Operator
Installation Instructions
I-EA00257 / 26790910
Rev 2, Rev Date: 1/30/19
Always visit www.hagerco.com for the latest Installation Instructions
HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 • (800) 325-9995
The Hager Series 8300 Operator has been carefully designed, built, and tested to provide years of
service.
The life of the operator package is directly related to how carefully the installation is accomplished
and how accurately the instructions are followed. Installation of this operator package should be
done by properly trained and knowledgeable installers with knowledge of local code requirements
and the requirements of ANSI A156.10 Standards for Power Operated Pedestrian Doors and
A156.19 Standards for Low Energy and Power Assisted Pedestrian Doors. The authorized service /
installation dealer must perform all measurements for forces, speeds, and times to insure proper
and safe operation.
Hager Companies is not responsible for improperly adjusted or maintained automatic doors or
activation / safety systems and assumes no responsibility for damages caused by automatic door
systems that have not been properly installed, tested, and adjusted.
OWNER INFORMATION TO BE PROVIDED BY THE DISTRIBUTOR / INSTALLER
After the installation instruct the owner on the safe operation of the door.
Location and proper use of the power switches.
Location of the main cutoff breaker.
Necessary warnings not covered in general instructions.
Owner’s Manual and Daily Safety Checklist.
Phone number(s) for the local servicing dealer.
What to do in the event that a dangerous situation should occur and how to shut the doors
down and call for service.
READ INSTALLATION INSTRUCTIONS BEFORE INSTALLING.
The sequence of installation
and adjustment is in order; however some sections will not apply. Review this instruction manual
and determine those sections that do apply. Be sure all doors swing freely and clear all objects
before attaching arms. Special attention needs to be given to installations with parallel and slide
arms when an adjacent wall is perpendicular to the door frame.
TABLE OF CONTENTS
OWNER INFORMATION & TABLE OF CONTENTS………….………………………. 2
PRODUCT DESCRIPTION, SPEC & TOOLS REQUIRED.……….………….………. 3
HEADER INSTALLATION...………………………………………………………………. 4-5
HANDING……..…………………...…..…………………………………………..……….. 6
PUSH ARM INSTALL………………………………………………………..…………….. 7
PULL ARM INSTALL………………………………………………………………….……. 8
MECHANICAL STOP ADJUSTMENT……………………………………..….…….……. 9
A/C WIRING………………………………………………………………………………… 10
CONTROL BOARDS………………………………………………………………………… 11
COMMISIONING…………...…..………………………………………………………..... 12
PAIRED OPERATORS……………………..……………………………………..……….. 13
FIRE RATED APPLICATIONS…….……..……………………………………..……….. 14
SW2 DIP SWITCH SETTINGS…………..……………………………………..……….. 15
J4, J5, AND J6 TERMINAL INPUTS…………...…………………………..………..…. 16
WIRING DIAGRAM……………………………………………………………...………… 17
TROUBLE SHOOTING…………………………..…………….….………………..……… 18
Owner Information & Table of Contents
Page 2 of 18
