8300 Low Energy Auto-Operator
Installation Instructions
I-EA00257 / 26790910
Rev 2, Rev Date: 1/30/19
Always visit www.hagerco.com for the latest Installation Instructions
HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 • (800) 325-9995
Commisioning
The commissioning step allows the operator to learn the door weight, motion, and stop location.
This step must be performed on all new installations or anytime the operator stroke is altered
in any way.
To begin commissioning…
1.
Ensure main power is on.
2.
Verify the adjustment board dip switches SW2 are set as desired.
3.
At the I/O control board, press the SW1 button for approximately 5 seconds. When the red LED (DL2)
on the Adjustment Board begins flashing rapidly, release the button.
If the red LED (DL2) does not start flashing, verify that you are pressing the SW1 button on the I/O
control board and not the SW1 button on the Adjustment Board.
4.
The door will slowly open, recycle partially, close and re-open.
5.
Do not interrupt the process and do not move the door manually during this time.
6.
If the door does not open and the red LED (DL2) is flashing slowly, verify that the motor is plugged in
properly at the control board. Correct as necessary.
7.
Once commissioning is complete, the door will close and the LED will go out.
8.
Commissioning complete.
9.
Upon commissioning completion, activate the door to open and ensure all performance is acceptable.
Adjust opening/closing speeds and hold open time as required.
DL4 will illuminate yellow anytime a change has been made to the control, such as speed or time
adjustment. Momentarily press Adjustment Board SW1 to acknowledge the change and extinguish
the yellow LED.
If speeds or hold open time are changed, a re-learn is not required.
Notes:
A re-learn is not required following a main power recovery.
Speed and time adjustment changes will not take effect until the door closes fully after the adjustment
has been made.
Additional adjustments are available with the Hager programmer (part number 2-679-0907)
Page 12 of 18
