1. MOUNTING INSTRUCTIONS
Check the content of the box while purchasing and make sure that it contains all the
components (2 toe units, 2 heel units, 16 x 11mm screws, 1 paper drilling template).
Hagan ZR bindings should be mounted by skilled staff, preferably an
AUTHORIZED or
SPECIALIZED DEALER
of Hagan products
.
We recommend the use of a
Hagan
Mechanical Drilling Jig
to mount the bindings. If you don’t have a Hagan mechanical
drilling jig you may use the
Hagan paper drilling templates
included in the binding
packaging. Then follow the instructions described in the next section.
IT IS IMPORTANT TO STRICTLY ADHERE TO THE INSTRUCTIONS IN THIS GUIDE.
FAILURE TO DO SO COULD RESULT IN INCORRECT SKI/BOOT ALIGNMENT AND/
OR IMPROPER BINDING FUNCTION.
PAPER DRILLING TEMPLATE INSTRUCTIONS
1)
Trace the longitudinal ski center line to achieve the correct alignment of toe and
heel . (Picture 1)
2)
If the toe position point is already marked on the ski, proceed to point 3 of the
instructions, otherwise please proceed as follows:
-
Place the ski boot center mark in line with the ski boot center line marked on
the ski.
-
Mark across the ski a line aligning with the inserts at the toe of the ski boot.
(Picture 1)
Picture 1
3)
Place the drilling template on the ski with the arrow placed toward the ski tip and
align:
•
Continuous Line “3” with the longitudinal center axis line on the ski.
Summary of Contents for ZR
Page 9: ...ILLUSTRATIVE PICTURES...
