HDE 24.
01.
201
2
Ma
ß
e
in
mm – Dimensions in mm
–
Dime
n
sions en
mm
– Medi
das
en
mm
- Misure
in
mm
C
at.
N
o. 732
.2
9.1
3
5
13
4. Installation
The installation instructions are a separate document and are enclosed with the product.
They are exclusively intended for:
• The
operator
,
• The
installation and start-up personnel
.
5. Start-up
The product is supplied in so-called simple mode for stand-alone operation (SA). These
instructions only describe how to start up in this mode.
Details on the use of the product with software applications can be found in the relevant
software documentation.
Configuration / reading out audit trails with the MDU
This description is in a separate document „Configuration of the FT 120 and administration of
the keys with Dialock SERVICE software“.
5.1 Initial
start-up
The initial start-up is only possible once after connecting the mains plug to the socket for the
first time. The individual instruction steps must be carried out within a short time window. Therefore:
• Study every instruction step and have the keys that are needed available before commencing
with initial start-up.
• Perform the instruction steps quickly and without interruptions.
6. Allocating locking authorisations
6.1 Keyed
alike
operation
Up to 16 MLA 8s can be switched in sequence in this operating mode, i.e. up to a maximum of
128 outputs can be controlled.
WARNING
Life-threatening electric shock during the installation with a plugged in mains plug!
The entire installation process must occur without power!
> Never connect the mains plug to the socket during the installation process.
> Even
after completing
the installation process, do
not
connect the mains plug.
The “
initial start-up
” is thereby immediately started.
> Prior to connecting the mains plug for the first time, first read chapter
“
Initial Start-Up
” of the
operating instructions
.
For step-by-step instructions „
Start-up - Allocating programming and clearing
keys
“ see illustrations on page
44
ff.
NOTE
Warning of abuse!
Unauthorised persons obtain locking authorisations with programming and clearing keys.
> Only personnel who are authorised by the operator may allocate locking authorisations!
> Take care when allocating locking authorisations to avoid overlapping or mistakes.
> Keep programming and clearing keys in a safe place and protect from abuse.
For step-by-step instructions „
Allocating locking authorisations - keyed alike
“
see illustrations starting on page
45
.
BA_DFT.book Seite 13 Dienstag, 24. Januar 2012 10:37 10
