9
INSTALL THE DUST CHUTE
Slide dust chute onto end of chip exhaust. Tighten pan head screw.
INSTALLING THE FILTER BAG
Open the zipper on the bottom of the bag, place the spring inside of the filter bag arm.
Slide the spring & bag over the dust exhaust port
Close the zipper.
OPERATION INSTRUCTIONS
Jointing is a surfacing operation in which a small amount of wood is removed from the edges and
faces of boards to get smooth, straight and even surfaces such that the two edges that run across
the planning blocks would fit together perfectly, forming a seamless joint.
Planing refers to the sizing of lumber to a desired thickness while creating a level surface parallel
to the opposite size of the board. Depth of cut is the term used to indicate how deep the blades will
cut into the workpiece.
ADJUST THE DEPTH OF CUT
The depth of cut is adjusted by the relative positioning of the infeed table with respect to the cutterhead.
Infeed table can be raised or lowered using the handwheel.
Turning the handwheel counterclockwise will lower the infeed table causing more wood to be removed from
workpiece.
Dust chute
Spring ( inside bag)
Dust Bag
Summary of Contents for WoodMaster PJ-6B
Page 15: ...15 EXPLODED VIEW...
