- 18 -
Adjust the level of the machine to make sure the allowance is under
0.04/1000mm in the across and horizontal direction after fixing the
machine on the base by four bolt.If necessary pads under the base.
Trial Run
Before trial tun. Please carefully clean the anti-rust oil on
the every part of the machine .But the metal tools and other tools
which can hurt the parts surface are forbidden.Then coat a thin
lager oil on the outer surface.
Lubricate the sliding and rotating part before trial
run.Pour engine oil into the Gear Box and the Power
Feed .Till indicating through the point then do a overall
check.
Bofore putting the power,examine if the power
parameters is consistent with the indicated parameters on
the machine’s date plate and at the same time the round
direction of the spindle is all right.During the trial
run,first run the machine unloaded at the lowest speed for
around 30 min’s then increase the speed step by step and
mean while inspect if the handwheel or handle operates
easily or reliably etc.
Notice:Must loosen the tighten handle before move the
moving part.
Page 19
Instruction Manual for HM-51B (M577)
25/03/2019
