5
TO AVOID
serious injury and damage to the machine,
read and follow all Safety and Operating Instructions
before assembling and operating this machine.
This manual is not totally comprehensive. It does not
and can not convey every possible safety and opera-
tional problem which may arise while using this
machine. The manual will cover many of the basic and
specific safety procedures needed in an industrial envi-
ronment.
Below is a list of symbols that are used to attract your
attention to possible dangerous conditions.
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety mes-
sages that follow this symbol to avoid possible injury or
death.
Indicates an imminently hazardous situation which, if
not avoided, WILL result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, COULD result in death or serious injury.
Indicates a potentially hazardous situation, if not avoid-
ed,
MAY
result in minor or moderate injury. It may also
be used to alert against unsafe practices.
CAUTION
used without the safety alert symbol indi-
cates a potentially hazardous situation which, if not
avoided, may result in property damage.
This symbol is used to alert the user to useful informa-
tion about proper operation of the machine.
GENERAL SAFETY
DANGER
NOTICE
CAUTION
Exposure to the dust created by power sanding, saw-
ing, grinding, drilling and other construction activities
may cause serious and permanent respiratory or
other injury, including silicosis (a serious lung dis-
ease), cancer, and death. Avoid breathing the dust,
and avoid prolonged contact with dust.
2.
ALWAYS
wear eye protection. Any machine can
throw debris into the eyes during operations,
which could cause severe and permanent eye
damage. Everyday eyeglasses are
NOT
safety
glasses.
ALWAYS
wear Safety Goggles (that
comply with ANSI standard Z87.1) when operat-
ing power tools.
WARNING
CAUTION
Some examples of these chemicals are:
Κ Lead from lead-based paints.
Κ Crystalline silica from bricks, cement and other
masonry products.
Κ Arsenic and chromium from chemically-treated
lumber.
Always operate tool in well ventilated area and pro-
vide for proper dust removal. Use a dust collection
system along with an air filtration system whenever
possible. Always use properly fitting
approved
respiratory protection appropriate for the
dust
exposure, and wash exposed areas with soap
and
water.
1. To avoid serious injury and damage to the machine,
read the entire User Manual before assembly and
operation of this machine.
!
!
!
!
WARNING
!
WARNING
!
WARNING
!
www.machineryhouse.com.au
www.machineryhouse.co.nz
Page 6
Instructions Manual for T-13A (W813)
1
1/9/19
