Hafco Woodmaster BP-430A, Operation Manual

Page: 14 / 49

14
OPERATION MANUAL
F
ig
. 4.9
h
ex
h
eaD
b
olts
INSTALLING THE FENCE
F
ig
. 4.8
M
ounting
s
crews
1. Attach the back support square tube to the back of the
table with the two M6 x 16 socket head cap screws,
making sure that the rail is parallel to the table. (Fig. 4.8)
2. Attach the front rail to the table with the two M6 x 20
hex head bolts, 6mm lock washers, and 6mm flat washers.
(Fig. 4.9)
3. Install an M8 hex nut on the fence handle, then thread the
handle into the fence assembly, and tighten the hex nut
against the fence pivot block to secure the handle.
(Fig. 4.10)
4. Adjust the rail pad screw on the back end of the fence to
and check that the fence locks at both ends. (Fig. 4.11)
NOTE: The fence upright can be fitted in the low or in the high
position depending on the workpiece being worked.
F
ig
. 4.10
l
ock
n
ut
F
ig
. 4.11
CONNECTING THE DUST HOSE:
Fit the 4” dust hose over the dust port and secure it in place
with a hose clamp making sure it will not come off.(Fig 4.12)
These band saws create substantial
amounts of wood dust when operating, and should not be
used without an adequate dust collection system. Failure to
use a dust collector may result in short and longterm
respiratory illness.
F
ig
. 4.12