Hafco Woodmaster BP-430A, Operation Manual

Page: 13 / 49

13
OPERATION MANUAL
4.7 ASSEMBLY
The machine must be fully assembled before it can be oper-
ated. First clean any parts that are coated in rust preventative
to ensure the assembly process can proceed smoothly.
INSTALLING THE GUIDE POST HAND WHEEL
1. Attach the guide post hand wheel onto the shaft making
sure that the grub screw will locate on the flat on the
shaft. (Fig. 4.4)
INSTALLING THE TABLE
The table is heavy and will require the assistance of another
person. To make the installation easier, first remove the saw
blade
To install the table
1. Release the blade tension on the saw blade move the
blade tension lever to the left. (Fig. 4.5)
2. Adjust the upper and lower blade guides so that the
blade is free to move.
3. Once the blade is removed with the help of another
person, lift the table on to the trunnion support bracket
and secure it with the four M8 x 16mm bolts, and M8 flat
and spring washers. (Fig. 4.6)
4. Remove the table insert and the table pin and slide the
blade through the table slot, making sure that the teeth
are facing down. (Fig. 4.7)
5. Place the blade between the upper and lower guides and
place the blade over the upper and lower wheels.
6 Tighten the quick release tension lever, then install the
table insert and table pin.
7. Don’t adjust the upper and lower blade guides until the
the blade tracking and tension have been adjusted.
F
ig
. 4.4
Hand
Wheel
F
ig
. 4.5
ïð
l
oosen
t
ighten
F
ig
. 4.6
F
ig
. 4.7
t
able
i
nsert
t
able
P
in