HAC-LBee/S manual V3.X SHENZHEN HAC TECHNOLOGY CO., LTD.
FAX:+86-755-23981007 E-MAIL
：
-
21 -
5.2.13 SH
<Diagnostics> The SH command is used to set and read the high 32 bits of the RF module's unique
IEEE 64-bit address.
Note: The 64-bit address has been set by the chip manufactory of the module in the factory. The
chip manufacture ensures the unique 64-bit address for each chip. In a Zigbee network, the 64-bit
address of each module is unique, otherwise, it will cause communication chaos. So we don
’
t
recommend the users to change the 64-bit address (Serial Number).
Command
ATSH(
Serial Number High
)
Range
0-0xFFFFFFFF
Parameter
Default Value
-
Minimum Firmware Version Required
：
0x1000
5.2.14 SL
<Diagnostics> The SL command is used to set and read the low 32 bits of the RF module's unique
IEEE 64-bit address.
Note: The 64-bit address has been set by the chip manufactory of the module in the factory. The
chip manufacture ensures the unique 64-bit address for each chip. In a Zigbee network, the 64-bit
address of each module is unique, otherwise, it will cause communication chaos. So we don
’
t
recommend the users to change the 64-bit address (Serial Number).
Command
ATSL(
Serial Number Low
)
Range
0-0xFFFFFFFF
Parameter
Default Value
-
Minimum Firmware Version Required
：
0x1000
5.2.15 SM
The SM command is used to set and read the sleep state of the module. The parameter is 0-5, 0
means working state, 1-5 means the sleep state.
When setting the sleep enable, it is controlled by the pin 9 (DIO5/SLEEP). When it is high level, it
is sleeping. When it is low level, it is working.
Under the sleep state, the sleep current is less than 1
µ
A.
