habitat et jardin 103109, Manual

Page: 11 / 16

WASTE
It is drained directly from the sewage
discharge outlet, to reduce the water level or
drain the water in the tank
It is drained directly from the
sewage discharge outlet,
without flowing through the
filter layer
RECIRCULATE
It is the water in water circulation tank,
without flowing through the filter layer
The water flows directly into
the water tank via the water
control valve, without
flowing through the filter
layer
CLOSED
Close all water flows through the filter into the
water tank
Control valve operations
WARNING: There is risk of electric shock. This product is only connected to the outlet with
grounding protection. If it can not be confirmed, please contact an experienced electrician for
installation, this outlet has a maximum leakage current of up to 30mA.; please do not use the movable
outlet.
WARNING: To reduce the risk of electric shock, do not connect any extension wire, timer, plug
adapter or converter to the filter body. Please provide a fixed outlet.
WARNING:
If you stand in a place with water or your hands are wet, do not unplug the power wire plug.
WARNING: When the reading displayed on the pressure gauge of the body exceeds a predetermined
maximum data, do not start this product.
WARNING: Before operation, always ensure that all bellows are connected
and locked and the filter is filled with the exact volume of sand.
WARNING: Before operation, always ensure that the product is connected to
the outlet with grounding protection.
WARNING: There is a closing position on the control valve. Do not start the
product when the control valve is in the closing position.
1.When rotating the control valves, press down the control valve handle first,
and then turn the control valve handle to the desired position (Fig. 13).
Operation steps
1.Ensure that the product is powered off.
2.Turn off the plug (3) on D position, and connect 3238 straight connector (18) and bellows (30) on C
position to D position.
3.Press down the control valve handle and turn it to the discharge position, and power on the product
for sewage drainage (Fig. 20). After the sewage drainage is completed, please power off the product.
4.Turn the control valve handle to the backwash position and turn on the power supply, until the clean
water is drained. (Fig. 20)
5.Disconnect the power supply. Remove 3238 straight connector (18) and the bellows (29), connect
Fig.
19