habitat et jardin 103109, Manual

Page: 14 / 16

1.
Before the water tank is drained or leveled, must ensure that the drainage direction towards the drainage ditch and
is away from the building. For special requirements about water treatment, please see the local regulatory
requirements.
2.Turn off the product switch and unplug the power plug.
3. After the water is drained fully, remove all filter covers connected to the sand filter pump, the
bellows and the pool wall.
4.As shown in Fig. 26, counterclockwise unscrew the drain tube cap (12) to thoroughly drain the
water in the body.
5.Dry the sand filter parts and bellows in the air.
6. The best storage way is to store all accessories and motor into their original package container. To
avoid shrinkage or corrosion problems, do not use any plastic bag to cover or wrap the motor.
7.Please store the motor and accessories on a dry location at the temperature of 32
°
F (0
°
C) ~
104
°
F (40
°
C)
Fault detection and troubleshooting
Fault Detection Solution
The motor can not
be started normally
The power supply is not
plugged properly
The leakage protection
is disconnected
The motor is overheated
or overloaded,
resulting in its shutdown
Ensure the power cord is plugged in 3-wire metal outlet with
grounding protection
Reset the circuit breaker switch. If the problem continues, there
may be a power supply problem, it should be turned off and
contact a power supply expert for processing
Cool down the motor in the air and restart it
Filter
The water tank can
not be cleaned
There is no sand in the
body
The
control valve
position is incorrect
There is excessive dirt in
the water
The filter element is
blocked
For sand filling, see the sand filling instructions
The control valve is turned to FILTER position
The running time is extended
Clean the filter element
The filter can not be
drained or drained
slowly
There are obstacles at
the entrance
There is air leakage at
the entrance
There is excessive dirt in
the water
The filter medium is
clogged with impurities
The tank is attached
with the cleaning device
Check and clean the obstacles in inlet and outlet tubes
Tighten the tube port nut and check the damaged point and water
level
Clean the strainer
Backwash
Remove the cleaning device attached to the tank
The filter can not be
operated
The water level is too
low
The strainer is clogged
The inlet tube is leaked
The motor is blocked or
the impeller is blocked
Add the water to adjust the water level
Clean the strainer in the tank
Tighten the tube port and check the damaged point
Please contact Customer Service Center for replacement