habitat et jardin 103109, Manual

Page: 10 / 16

Step V
As shown in Figs 16 and 17, connect ĭ 38 bellows (23) between the control valve B port and the
motor B port, and tighten 32-50 hoop (21) with a flathead screwdriver.
Sand filter pump and water pool installation:
Installation steps: As shown in Fig 12, connect
ž
32 bellows to the water pool and the sand filter
pump, tighten clockwise 25-42 hose clamps (28) with a flathead screwdriver; and then power on the
sand filter pump to filter the water in the pool.(
Be sure to follow the instructions to connect the pump and pool,Any
change of valve position, pump size, grille size can cause a change of the flow and the suction velocity can be increased
)
Control valve position and functions
Control valve position Functions Water flow direction
FILTER Water tank with normal filtering
The water flows into the
water tank via the sand filter
layer.
BACKWASH Backwash the filter layer
After the water is filtered via
the sand filter, the sewage is
drained directly from the
sewage drainage outlet.
RINSE
In the first start, it is used to clean the sand in
the sand cylinder and level the backwashed
sand
The water flows through the
sand filter layer and is
drained directly from the
sewage drainage outlet
Fig. 18