Operating instructions 36001
Hot-pressing device
PT-55
Page 16 of
19
Edition: 04/0401
Subject to alterations
9.3 Preparing
devices
9.3.1 Manual skiving tool AT-60
The AT-60 is a preparing device for skiving of Habasit belts and tapes up to a width of 60 mm /
2.4 in.
and a
thickness of 2 mm /
0.08 in.
. The belt / tape is clamped and stuck on a steel plate. It is ground manually by
means of a skiving disc. Adjustment is done with two different settings.
The AT-60 is especially suitable for occasional preparation of single belts or spindle tapes on site in
maintenance.
→
ill. (7)
9.3.2 Skiving tool AT-200
The AT-200 is a preparing device for skiving of Habasit belts and tapes up to a width of 200 mm and a
thickness of 7 mm. The belt is clamped and stuck on a steel table. This table is adjustable in tilt in six steps;
it is fed under a grinding drum on precise guides. For the drive of the unit there are two options: The device
equipped with a high-torque power drill, or with a stub axle to be driven / motorized according to the desires
of the customer. Feed of the table is by means of a hand wheel.
The AT-200 is suitable for preparation of belts and tapes in small to medium series.
→
ill. (8)
Illustration 7
Illustration 8
