www.
HAAN
USA.com 877-HAAN DIRECT / 877-422-6347
pg 17
Helpful Hints
Be sure to always vacuum or sweep up loose dirt before
steam cleaning your floors. The FS-20 does not have any
suction power.
The easiest way to use the FS-20 is to tilt the handle to
a 45° angle and push and pull the unit slowly across each
section of your floor – approximately 2 to 3 yards at a time.
To release the handle/pole in preparation for using the
FS-20, simply place your foot gently on top of the main
unit and pull back. Be sure not to confuse the yellow
power button as a release for the handle.
A good amount of steam passes through the Ultra-Microfiber
Pad. We recommend that the Ultra-Microfiber Pad be
changed when it gets too wet; these need to be replaced
as necessary. Your FS-20 or FS-20+ includes two Ultra-
Microfiber Pads.
While the FS-20 effectively cleans dirt and grime from
hard-surface floors, particularly stubborn stains on vinyl
or linoleum floors may be pre-treated with a mild detergent
and a little water before using the Steam Cleaning Floor
Sanitizer.
Always let the Floor Sanitizer cool for at least 5 minutes
before removing the Ultra-microfiber Pad and emptying
the water tank.
Never leave the FS-20 in one spot on any surface for any
period of time. Always place your FS-20 on the black
Protector Mat (with the “bumpy” side facing up) when
stationary, and make sure the Floor Sanitizer is turned off
when not in use.
Do NOT attempt to use the FS-20 in a vertical position (ie:
to clean a tile wall) as this may cause leaking or malfunc-
tion of the product.
You may use your FS-20 Steam Cleaning Floor Sanitizer
to clean counter tops and other hard surfaces, as well as
bedding, upholstery and other soft surfaces by using our
special short handle attachment. This optional attachment
is available for purchase through our web site: www.
Haan
USA.com or by calling our Customer Care center
at 1-877-
Haan
-DIRECT (1-877-422-6347).
