Using Your Floor Sanitizer
pg 8 877-HAAN DIRECT / 877-422-6347 www.
HAAN
USA.com
1)
Remove all parts from the packaging.
2) Assemble the unit as described on page 6.
3)
IMPORTANT:
Make sure you remove the clear
plastic film that is over the Thermal Indicator on
the water tank cap. Failure to do this could inhibit
the sensor and give an incorrect reading. DO NOT
remove the black sensor.(Fig 1)
4) Place the Floor Sanitizer on the black Floor
Protector Pad (be sure the “bumpy” side is facing
up), and open the tank filling cap. (Fig 2)
5) Using the provided fill cup, pour no more than
one fill cup of water (as indicated by the fill line
on the cup) into the tank.
Do not overfill
. There is
a gray bar just inside the opening of the Water Tank
to show the correct water level. Replace the cap
when finished. (Fig 3)
6) Plug the Floor Sanitizer into a standard 120-volt
grounded wall receptacle.
7) Press the YELLOW ON/OFF power button to turn
your Floor Sanitizer ON. The GREEN Power ON
light will illuminate. (Fig 4)
NOTE: The YELLOW button can sometimes be
confused as a release for the handle/pole of the
FS-20. The YELLOW button is the POWER button
only. To release the handle/pole, simply place your
foot gently on top of the unit and pull back.
Your Floor Sanitizer is ready to use when the
Thermal Indicator on the tank cap changes from
black to orange.This usually takes less than 3
minutes but no longer than 5 minutes.
8) Place an Ultra-Microfiber Pad on the floor with
the ‘hook & loop’ side facing up. Lightly press
the Floor Sanitizer on the pad making sure the
Ultra-Microfiber Pad is centrally positioned to
the bottom of the unit. The specially designed
bottom of the HS-E2010Y will grip the pad.
DO NOT attach the pad crossways to the bottom
of the unit. (Fig 5a & 5b)
Operating Instructions:
Fig 1
Fig 2
Fig 5
Fig 3
b
a
Fig 4
Remove
film
Remove
cap
GREEN
Power
Light
ON/OFF
Button
Yes
NO!
