H3C WA2620X-AGNP, Web-Based Configuration Manual, Page: 156 / 447

143
Task Remarks
IP Config
Configure the way the dialer interface obtains its IP address:
•
None: Not configure IP address
•
Static Address: Statically configure an IP address and subnet mask for the
interface
•
PPP Negotiate: Obtain an IP address through PPP negotiation
•
Unnumbered: Borrow the IP address of another interface on the same device
IP Address
Configure an IP address and subnet mask for the dialer interface
If you select to configure a static IP address for the dialer interface, you must
configure both items.
Mask
Unnumbered Interface
Interfaces on the same device whose IP addresses are borrowed
If you select IP address borrowing for the dialer interface, you must configure this
item.
Bundled Interface Configure the interfaces bound to the PPPoE client
Session Type
Set the session type of the PPPoE client to Always Online or Not Always Online.
•
Always Online: When the physical link is up, the device immediately initiates
a PPPoE call to establish a PPPoE session. The PPPoE session continues to exist
until you delete it.
•
Not Always Online: When the physical link is up, the device does not initiate
a PPPoE call unless there is data to be transmitted on the link. When the PPPoE
link stays in idle state longer than the timeout timer set by the user, the device
terminates the current PPPoE session automatically. When selecting the
non-permanent connection mode, you need to set an idle-timeout timer.
Idle Time
Set an idle-timeout timer for the PPPoE link.
This item is required when you set the session type to
Not Always Online .
Displaying PPPoE client session statistics
1. Select Network > PPPoE from the navigation tree.
2.
Click the
Session
tab to enter the page for displaying the session information.
3. Select Statistic Information for Information Type , as shown in Figure 150 .
4. Display the PPPoE client session statistics as described in Table 62 .