9
3
Installation (indoor)
This chapter includes instructions for installing the WA2210-AG and WA-2220AG indoor AP
models directly on a desk or attaching it to a wall using the wall-mounting bracket.
Determining installation location
Determine the installation position by observing the following principles:
Have as few obstacles (such as wall and ceiling) as possible between the AP and stations.
Keep the AP far away from electronic devices (such as microwave oven) that may
generate RF noise.
Install the AP in a place where it will not interfere with people’s daily work and life.
Do not install the AP in an area where it may come in contact with water or condensation.
Prevent water or moisture from entering the AP.
CAUTION:
When mounting on the ceiling, ensure that the intensity and structure of the ceiling meet the
requirements for ceiling mounting. H3C recommends reinforcing weak ceilings, and securing the unit
with a padlock to prevent falloff in case of vibration or shock.
Installing the AP
This section describes how to install the AP on a wall:
Installing the wall-mounting bracket on a wall
Installing the AP on the wall-mounting bracket
Optional: Locking the AP onto the wall-mounting bracket
Installing the wall-mounting bracket on a wall
To install the wall-mounting bracket on a wall:
1.
There are eight installation holes in the wall-mounting bracket. Use at least four holes for
installation. Measure and mark the wall where the AP should be mounted. Ensure holes
correspond to those in the bracket (see Figure 3 Using a 6 mm (0.24 in) bit, drill holes on the
markings.
