8-2
Step3
Select a slot and push the MIM into the chassis until it is fully seated in the slot and its front panel is flush
with the front of the chassis.
Step4
Tighten the captive screws to secure the MIM.
Step5
Power up the V100-E and check the state of the ACT LED for the slot on the V100-E. Blinking means
the MIM is installed correctly.
Figure 8-1
Install the MIM I
Figure 8-2
Install the MIM II
Removing an MIM
Follow these steps to remove an MIM:
Step1
Place the V100-E with its front panel facing you.
Step2
Turn off the site power and remove the power cord.
Step3
Remove all interface cables from the front of the chassis.
Step4
Loosen the captive screws at both sides of the MIM.
Step5
Pull the MIM towards you until it is completely separated from the bottom of the chassis.
z
If you do not install a new MIM in the slot, install a blank panel to prevent dust from entering the
chassis.
z
Do not operate at MIMs near the passageway to avoid accidents to the unit or the removed MIMs.
