4-30
Replacing a power supply for an F1000-AI-60, F1000-AI-70,
F1000-AI-80, or F1000-AI-90 firewall
The replacement procedure is the same for an AC power supply and a DC power supply. This
section takes an AC power supply as an example.
To replace a power supply for an F1000-AI-60, F1000-AI-70, F1000-AI-80, or F1000-AI-90 firewall:
1.
Face the rear panel of the firewall.
2.
Remove the releasable cable tie from the power cord and then remove the power cord
connector from the power supply.
3.
Hold the power supply handle with one hand, press the latch towards the handle, and then pull
the power supply part way out of the slot. Supporting the power supply bottom with one hand,
slowly pull the power supply out of the slot along the guide rails with the other.
4.
Put the removed power supply in an antistatic bag or on the workbench.
5.
Install a new power supply. For the installation procedure, see "
Installing a power supply for an
F1000-AI-60, F1000-AI-70, F1000-AI-80, or F1000-AI-90 firewall
If you are not to install a new power supply, install a filler panel in the slot to ensure good
ventilation in the firewall.
Figure4-2 Removing a power supply from an F1000-AI-60, F1000-AI-70, F1000-AI-80, or
F1000-AI-90 firewall
Replacing an interface module
CAUTION:
•
Interface modules are not hot swappable. Power off the firewall before you replace an interface
module.
•
To install two or more interface modules, use the upper interface module slots as a best practice.
If you have installed an interface module in a lower slot, you must press down the ejector levers
of the interface module while inserting it into an upper slot.
The F1000-AI-10 does not support interface modules.
To replace an interface module:
1.
Power off the firewall.
2.
Use a Phillips screwdriver to loosen the captive screws of the interface module.
3.
Holding the ejector levers of the interface module with both hands, pull the ejector levers
outward, and pull the interface module part way out of the slot along the slide rails. Supporting
the bottom of the interface module with one hand, gently pull the interface module out of the slot
with the other.
3
3
1
2
