19
5.
Use a Phillips screwdriver to fasten the captive screws on the module.
Figure2-19 Installing an interface module
Installing a drive
CAUTION:
•
Drives are not hot swappable.
•
To avoid damage to drives, always hold a drive by its sides. Do not touch any components and do
not squeeze, vibrate, or strike a drive.
•
Install a filler panel in empty drive slots to prevent dust and ESD damage.
IMPORTANT:
•
The device does not come with any drives and cannot recognize drives from other vendors.
Purchase drives from H3C as needed.
•
Before using the drive, execute the
fdisk
and
format
commands from the CLI to partition and
format the drive.
Installing a drive for an F1000-AI-10 firewall
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel from the drive slot.
3.
Push the drive into the slot slowly along the guide rails.
Figure2-20 Installing a drive for an F1000-AI-10 firewall
Installing a drive for other firewalls than the F1000-AI-10
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
3
3
2
2
1
1
2
