5
{
Processes jumbo frames within the specified length.
{
Discards jumbo frames that exceed the specified length.
To configure jumbo frame support in interface view:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Ethernet interface
view.
interface interface-type
interface-number
N/A
3.
Configure jumbo frame
support.
jumboframe enable
[
size
]
By default, the switch allows jumbo
frames within 12288 bytes to pass
through all Ethernet interfaces.
Configuring physical state change suppression on an
Ethernet interface
IMPORTANT:
Do not enable this feature on an interface that has RRPP, spanning tree protocols, or Smart Link
enabled.
The physical link state of an Ethernet interface is either up or down. Each time the physical link of an
interface comes up or goes down, the interface immediately reports the change to the CPU. The
CPU then performs the following operations:
•
Notifies the upper-layer protocol modules (such as routing and forwarding modules) of the
change for guiding packet forwarding.
•
Automatically generates traps and logs to inform users to take the correct actions.
To prevent frequent physical link flapping from affecting system performance, configure physical
state change suppression. You can configure this feature to suppress only link-down events, only
link-up events, or both. If an event of the specified type still exists when the suppression interval
expires, the system reports the event.
When you configure this feature, follow these guidelines:
•
To suppress only link-down events, configure the
link-delay
[
msec
]
delay-time
command.
•
To suppress only link-up events, configure the
link-delay
[
msec
]
delay-time mode up
command.
•
To suppress both link-down and link-up events, configure the
link-delay
[
msec
]
delay-time
mode updown
command.
To configure physical state change suppression on an Ethernet interface:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Ethernet
interface view.
interface
interface-type
interface-number
N/A
3.
Configure physical
state change
suppression.
link-delay
[
msec
]
delay-time
[
mode
{
up
|
updown
}]
By default, the link-down or link-up event is
immediately reported to the CPU.
If you configure this command multiple times on
an Ethernet interface, the most recent
configuration takes effect.