3-6
IMPORTANT:
Captive screws are required to install a service module on the device. As a best practice, fasten a
captive screw to a torque of 5.5 kgf-cm (4.77 lbf-in).
For the compatibility between the device and the service modules (also called interface modules),
see
H3C S12500R Switch Router Series Hardware Reference
.
The service module ejector levers and the ejector lever pillow blocks on the service module slots
have purple marks.
To install a service module:
1.
As shown by callout 1 in
, remove the filler panel from the target service module slot.
Keep the removed filler panel secure for future use.
2.
As shown by
, orient the service module upside up based on the orientation of
characters on the service module. Holding the service module by the front panel with one hand
and supporting the bottom with the other, push the service module steadily into the slot along
the guide rails.
Keep the service module parallel to the slot to avoid touching other components in the chassis.
3.
As shown by callout 2 in
, pull the ejector levers of the service module outward when
most part of the service module is inserted in the slot.
4.
Push the service module until the brakes on its ejector levers touch the slot edges tightly.
5.
As shown by callout 3 in
, continue to push the service module by its middle part on
the front panel until you cannot push it further.
6.
As shown by callout 4 in
, push the ejector levers inward until they come in close
contact with the front panel.
7.
As shown by callout 5 in
, fasten the captive screws on the service module.
