2-4
Figure 2-3 Installing cage nuts
Mounting the device in a rack
CAUTION:
•
Hold the chassis handles to move the device. Do not hold the handle of a fan tray, a power
supply, or a module to move the device. Any attempt to carry the device with these parts might
cause equipment damage or even bodily injury.
•
After you place the device on the slide rails, do not leave go of your hands immediately because
this might tip the device, damaging the device or even causing bodily injury.
•
Do not place your hand into any slot when you move the chassis.
To mount the device in the rack:
1.
Face the rear of the chassis towards the front of the rack.
2.
Move the device by holding the chassis handles.
3.
Place the device on the slide rails from the front of the rack and slide the device along the
guide rails until the mounting brackets on the device touch the front rack posts tightly, as
shown by callout 1 in
4.
Use the provided M6 screws provided with the device to attach the mounting brackets to the
rack posts. The recommended torque for the M6 screws is 30 kgf-cm (2.94 Nm).
If the mounting holes in the mounting brackets cannot align with the cage nuts on the rack,
verify that the cage nuts are installed correctly. For cage nut installation, see "
nuts for attaching mounting brackets
".
1RU
1RU
