3-5
3.
As shown by callout 3 in
, pull the interface module part way out of the slot. Holding
the interface module by the front panel with one hand and supporting the bottom with the other,
pull the interface module steadily out of the slot along the guide rails.
To avoid touching other components in the chassis, keep the interface module parallel to the
slot while pulling it out.
Figure 3-5 Removing an interface module
Installing a filler panel in an empty interface module slot
An interface module slot filler panel is provided with the device. If you are not to install an interface
module in an interface module slot, install the filler panel in the slot.
To install a filler panel in an empty interface module slot:
1.
, align the two captive screws on the filler panel with the
installation holes on the slot.
2.
As shown by callout 2 in
, fasten the captive screws on the filler panel.
The recommended torque is 5 kgf-cm (0.49 Nm).
Figure 3-6 Installing the filler panel in an empty interface module slot
Installing cable management brackets
CAUTION:
To avoid device damage, press the spring tab when you remove a cable management bracket.
2
2
3
1
1
1
2
2
