H3C H3C S5100-SI, Operation Manual, Page: 338 / 830

2-1
2
IP Performance Optimization Configuration
When optimizing IP performance, go to these sections for information you are interested in:
z
IP Performance Overview
z
Configuring IP Performance Optimization
z
Displaying and Maintaining IP Performance Optimization Configuration
IP Performance Overview
Introduction to IP Performance Configuration
In some network environments, you can adjust the IP parameters to achieve best network performance.
The IP performance optimization configuration supported by S5100-SI/EI Series Ethernet Switches
includes:
z
Configuring TCP attributes
z
Disabling ICMP to send error packets
Introduction to FIB
Every switch stores a forwarding information base (FIB). FIB is used to store the forwarding information
of the switch and guide Layer 3 packet forwarding.
You can know the forwarding information of the switch by viewing the FIB table. Each FIB entry includes:
destination address/mask length, next hop, current flag, timestamp, and outbound interface.
When the switch runs normally, its FIB table and routing table have the same contents.
Protocols and Standards
z
RFC 793, Transmission Control Protocol
z
RFC 1323, TCP Extensions for High Performance
Configuring IP Performance Optimization
IP Performance Optimization Configuration Task List
Complete the following tasks to configure IP performance Optimization:
Task Remarks
Configuring TCP Attributes Optional
Disabling Sending of ICMP Error Packets Optional
Configuring TCP Attributes
TCP optional parameters that can be configured include: