H3C CR19000-16, Installation, Quick Start

Page: 28 / 46

7-3
Installing an interface module that uses detachable ejector
levers
CAUTION:
•
Put the detachable ejector lever back on its holder after use and then attach it to the chassis or
cabinet for future use.
•
The ejector lever holder is magnetic. Be aware of electromagnetic interference.
•
Do not use only one detachable ejector lever to install or remove an interface module.
•
Do not hold detachable ejector levers to lift an interface module.
Figure 7-3 Detachable ejector lever
To install an interface module that uses detachable ejector levers:
1. Wear an ESD wrist strap. Make sure the wrist strap makes good skin contact and is reliably
grounded.
2. Remove the filler panel from the target interface module slot.
Keep the removed filler panel secure for future use.
3. Remove the protection box (if any) from the connector side of the interface module, as shown
in
Figure 7-4 .
Keep the removed protection box secure for future use.