31
DO NOT DIVE.
105
DO NOT DIVE.
Regular Maintenance Procedures
Note: These maintenance procedures are the responsibility of the swim spa owner to perform. These
procedures are not covered by the swim spa warranty.
DRAINING YOUR SWIM SPA
Due to the physical size of the swim spa, we recommend draining your swim spa with a submers-
ible sump pump. Draining your swim spa with a conventional spa drain is not a reasonable option.
When draining the Momentum 80 swim spa always drain the water from the spa side before
draining the swim side. Your swim spa requires periodic draining and cleaning to ensure a safe,
healthy environment. It is recommended that you clean your swim spa at least every 180 days.
Heavy bather load will require cleaning it more often.
• Turn off power to your swim spa at the GFCI breaker.
• Carefully lower a submersible pump in to the spa to sit at the lowest point (for Momentum
model with the clear divider between the spa end and swim end, always pump out the spa side
first and then the swim side).
• Run the hose of your submersible pump to a desired discharge point.
• Plug in or turn on your submersible pump and run it until it has removed all the water that it
can.
CARE & CLEANING OF SWIM SPA SURFACE
• Clean the spa shell, jets and other controls with a soft cloth and spa shell cleaner to help remove
residue and buildup on the shell surface. For mineral based buildup, white vinegar or mild scale
remover product may be necessary to use with a soft cloth for removal. Consult with your local
Master Spas dealer for proper swim spa cleaning products.
• Rinse the cleaned surfaces with fresh water from your garden hose and wipe with soft cloth as
doing so to help remove residual cleaning agents as some may cause foaming to occur in the
water once refilled.
• Always use an approved insulating swim spa cover by Master Spas to cover your swim spa when
not in use, especially in outdoor installations where the swim spa is exposed to weather condi-
tions and sun. Constant, prolonged exposure and use of unapproved or non-insulating swim spa
cover can result in damage to swim spa surface which would not be warranted.
CLEANING THE CLEAR ACRYLIC DIVIDER (Momentum)
• The surface should be first flushed with clean water to remove loose abrasive particles. The clear
acrylic sheet should then be gently sponged with a mild soap/water solution and finally rinsed
with clean water. Care must be taken not to leave any of the soap residue in the swim spa as it
could cause the swim spa water to foam during operation.
• Drying can be done with a clean soft cotton towel. Avoid hard rough cloths or paper towels
since they can put fine scratches on the acrylic surface.
• Do not use any aggressive solvents (lacquer thinner, gasoline, acetone and etc.) on the clear
acrylic sheet. These products can cause damage to the sheet that may not be visible until days or
weeks later.
• Window glass cleaning compounds are not recommended. Cleaning products that contain any
type of abrasive material should not be used.
REFILL YOUR SWIM SPA
• When filling the Momentum swim spa always fill the swim side of the unit before filling the spa
side.
• Refer to the Water Maintenance Start-Up section for specific instructions.
