ELECTRO FREEZE Shake Model CS600
13 Troubleshooting Tables
- continued
PROBLEM
PROBABLE CAUSE
REMEDY
24
184596
Unit does not
operate.
1. Freezer unplugged.
1. Plug in freezer.
2. Fuse blown or breaker tripped at main
disconnect.
2. Make sure your freezer is connected to a
separate circuit independent from any other
electrical equipment. Have technician check
fuse or breaker size and check for low
voltage; if not within 10% of nameplate
rating call power company.
3. Actuator rod not installed
3. Install actuator rod.
4. Off on high pressure cut-out control.
4. Water turned off or defective water
regulating valve. Check water suppy.
5. Circuit breaker tripped.
5. Contact your Electro Freeze distributor for
service.
6. Faulty selector switch
6. Contact your Electro Freeze distributor for
service.
7. Disconnected or broken wire in electrical
circuit.
7. Contact your Electro Freeze distributor for
service.
Mix leaking at
dispensing
head.
1.
Faulty o-ring.
1.
Replace o-ring.
2.
Head not properly installed.
2.
Install head properly. Replace o-ring if
pinched.
Leakage of mix
or water from
drain tube to
drip tray.
1.
Damaged beater shaft seal or installed
improperly.
1.
Replace cup seals on washer. Install
properly.
2.
Beater shaft pitted or damaged where
o-ring rides.
2.
Replace beater shaft.
3.
Beater shaft end play not set properly.
3.
Contact your Electro Freeze distributor for
service.
Product
dispenses slowly
out of dispensing
head.
1. Product too cold.
1.
See Dispensed Product Too Hard.
