ELECTRO FREEZE Model CS600
184596
7
l
6.1 Selector Switch 1
This three-position switch selects the
mode of operation of the freezer.
a.
“CLEAN”
(left) — This position
operates the beater only (no refrigera-
tion). Always use this mode when
performing cleaning and sanitizing
operations.
b.
“OFF”
(center) — In this position
the beater motor and refrigeration
system will not operate.
Important:
Do not use the automatic position
with water or sanitizer in the cylinder
or hopper — the freezer will be dam-
aged.
c.
“AUTO”
(right) — This position
activates both the beater motor and
refrigeration unit. This is the normal
operating position.
6.2 Day– Night Switch 2
a.
“DAY”
(left) — The low tempera-
ture thermostat controls the system
refrigeration to maintain the product
serving temperature between 18
°
–21°F
(-8 to -6°C). This is the normal operating
position.
b.
“NIGHT”
(right) — This energy
saving mode will reduce product agita-
tion. The freezer will automatically cycle
to maintain temperatures below 41
º
F (5
º
C). Use this position when the freezer
will not be in use for periods of more
than an hour.
6.3 “ADD MIX” Indicator Light 3
Figure 6-1
CAUTION
Test operation of the head
switch prior to placing the
freezer in service. See Section
12, Routine Maintenance,
Monthly.
6 Operator Controls
The following paragraphs describe the
operator controls and indicators. Refer to
figure 6-1 for location of these controls and
indicators on the Model CS600 freezer.
NOTE:
The plunger rod must be in place
before the freezer will operate in “DAY”,
“NIGHT”, or “CLEAN” position.
Important:
If proper mix level is not maintained,
a freeze-up may occur and damage
the freezer.
When lit, this light indicates the mix in
the hopper is at a low level and should
be refilled as soon as possible. Always
maintain
at least
2 inches (5 cm) of mix
in the hopper. For best operating results
keep hopper full.
