28
TITANIUM 400 AC/DC
EN
• This equipment must be used and stored in a place protected from dust, acid, gas or any other corrosive substance.
• The machine must be placed in a sheltered area away from rain or direct sunlight.
• The equipment protection is rated IP23 meaning that :
- sensitive parts of the equipment are protected from objects with a diam >12.5 mm and,
- it is protected again rainfall with a 60° vertical incline.
The equipment can be used outside in accordance with the IP23 protection certification.
Power cables, extension leads and welding cables must be fully uncoiled to prevent overheating.
The manufacturer does not accept any liability in relation to damages caused to objects or harm caused to persons as the result
of incorrect and/or dangerous use of the machine.
MAINTENANCE / RECOMMENDATIONS
• Maintenance should only be carried out by a qualified person. A yearly maintenance is recommended.
• Ensure the machine is unplugged from the mains, and then wait 2 minutes before carrying out maintenance work. High Voltage
and Currents inside the machine.
• Remove regularly the casing and any excess of dust. Take this opportunity to have the electrical connections checked by a qualified person, with
an insulated tool.
• Regularly check the condition of the power supply cable. If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or an equally qualified person to prevent danger.
• Ensure the vents of the device are not blocked to allow adequate air circulation.
• Do not use this equipment to thaw pipes, to charge batteries, or to start any engine.
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorised by the manufacturer should perform the installation of the welding equipment. During the installation, the
operator must ensure that the machine is disconnected from the mains. Connecting generators in serial or in parallel is forbidden.
EQUIPMENT DESCRIPTION (FIG-1)
The TITANIUM 400 AC/DC is an inverter welding current source for welding to the coated electrode (MMA) and refractory electrode (TIG) in direct
current (TIG DC) and alternating current (TIG AC).
The MMA process allows to weld all types of electrodes : rutile, basic, stainless and cellulosic.
TIG welding requires gas shield protection of pure gas (Argon).
This material can be connected to a remote control (ref. 045675), a foot pedal (ref. 045682) or an automated system (CONNECT-5).
1-
HMI
8-
USB connector
2-
Handles
9-
ON / OFF switch
3-
Torch button connector
10-
Power supply cable
4-
Positive polarity plug
11-
Remote controller connector
5-
Polarity plug
12-
Gas bottle connector
6-
Torch gas connector
13-
Filter (option ref. 046580)
7-
Wire feeder connector or MMI remote interface
INTERFACE (MMI) (FIG-2)
1-
Button for accessing the various menus and parameters
2-
Adjustment wheel left screen
3-
Adjustment wheel right screen
ACCESSORIES AND OPTIONS
Remote controllers
Trolley
10 m
3
Cooling unit
WCU1KW_C
ABITIG
torches
liquids - 450 W - 8 m
Pedal RC-FA1
4 m
Manual RC-HA1
8 m
Filter
037328
013537
Double button: 037366
Lamella: 037359
Potentiometer: 060760
045682
045675
046580
POWER SWITCH
• This equipment is supplied with a 32A 3-phase 5-pin socket (3P+N+PE) of the EN 60309-1 type and is powered by a 400V (50-60Hz) 3-phase elec
-
trical installation WITH neutral grounded.
