INSTALLATION INSTRUCTION FOR 7760V SERIES
PANIC VERTICAL ROD EXIT DEVICE.
2 1/8" BORE IS
REQUIRED WHEN
OUTSIDE
KNOB OR LEVER
TRIM IS USED
G
HORIZONTAL
--..,
� CHASIS ,'
/
CHASIS --
ASSEMBLY
PULLMAN LATCH
TOP CHASIS
ASSEMBLY
STEEL TOP COVER
TOP ROD
0
�IFT ARM
AIN SLIDE
STEEL BOTTOM COVER
�
I
VERTICAL
� CHASIS
( LHRB)
MOUNTING
RAIL
HEAD COVER
END CAP
SURFACE OF DOOR FOR
EXIT DEVICE APPLIED MUST
BE FLUSHED.
PUSH RAIL
RAIL MOUNTING
BRACKET
��� PANIC BAR SET SCREWS (12-24 X 5/16") MUST BE ACTIVATED AT TOP AND
BOTTOM OF PUSH RAIL TO ACHIEVE IMPACT RATING.
SET SCREWS TO BE USED IN THE EVENT OF IMMINENT SEVERE WEATHER
OF HURRICANE FORCE.
BEFORE INSTALLING DEVICE, PLEASE CHECK:
1. IF DOOR FITTED AND HUNG.
2. SIZE OF EXIT DEVICE, FUNCTION AND DESIGN ...
2.1. 36"DOORS, CAN BE CUT TO FIT DOORS DOWN TO 30"
WIDE.
2.2. 48"DOORS, CAN BE CUT TO FIT DOORS DOWN TO 36"
WIDE.
2.3. HAND OF DEVICE AGAINST APPLICATION
OUT
RIGHT HAND
� �
LEFT HAND
REVERSE BEVEL � • � REVERSE BEVEL
TO CHANGE HAND OF 7760V EXIT DEVICE.
1.REMOVE CHASSIS PINS AND MAIN SLIDE.
2.REMOVE LIFT LEVER PIN AND LIFT LEVER.
3.REASSEMBLE LIFT LEVER AT OPPOSITE SIDE, AS SHOWN.
4.REPLACE MAIN SLIDE AND CHASSIS PINS .
.---CHASSIS PIN
LIFT LEVER PIN
MAIN SLIDE
EDG-410
2
-10/
2
3-1of
2
