14/29
USER IDENTIFICATION MODE :
User ID :
If the identification mode is set to "ON", then you should
enter all required fields of the repair order to the welding
points if the machine will issue the "defect identification.
To enable and disable the identification mode, insert an
SD card reader in the identification of BP instead of the
SD card that contains the programs.
The screen below setup is activated by pressing for 2
seconds on the mode button.
When the SD card "identification" is inserted and
you select "identify ON" THEN supervision following
screen appears.
This screen allows you to make the fields
“registration, vehicle make, vehicle model, vehicle
identification number "required when entering the
repair order.
To exit the screen, you must press the mode key for
2 seconds. Then you must put the SD card that
contains the program into your BP card reader.
List of screens that allow you to enter a
repair order:
When a job number has already been created, it
can not be changed or deleted on the BP. To
remove it you must use the software GYSPOT PC.
You can create up to 100 job numbers.
Screen : « Job number »
Keys 'left' and 'right' moves the cursor in the field.
The up and down buttons allow you to change the
letters or numbers
The short press the Esc key clears the field.
The mode button allows scrolling fields for the
modification or reading.
Screen : « user ID »
Summary of Contents for GYSPOT INVERTER BP.CX
Page 22: ...22 29...
Page 25: ...25 29 Type of arms for C clamp 3 C1 C2 C3 C5 C6 C4...
