12/29
Pressing again on the button allows to force the execution
of the welding spot, which will be performed with the air
pressure available. If the actual measured clamping force is
too low, then the machine will display the following
message “Low Pressure”.
Welding spot counter
A welding spot counter allows to count the number of spots
performed with the same caps. If the welding spot is
performed without any problem, the following message
appears.
The counter is displayed on the top left corner of the
screen. Pressing the key
resets this counter to zero,
after the caps have been replaced.
If more than 200 welding spots are done with the same
caps, then the machine will display a warning message. In
this case, the warning message “Do control caps” is also
recorded in the traceability report.
Summary of Contents for GYSPOT INVERTER BP.CX
Page 22: ...22 29...
Page 25: ...25 29 Type of arms for C clamp 3 C1 C2 C3 C5 C6 C4...
