50
NEOPULSE 220 C / 220 C XL
EN
The wire forms a bottleneck after the rollers.
The wire liner is crushed.
Check the liner and the torch.
The wire is blocked in the torch.
Replace or clean.
No capillary tube.
Check the presence of the capillary tube.
Wire speed is too high.
Reduce the wire speed.
The weld bead is porous.
The gas flow is insufficient.
Setting range from 15 to 20 L/min.
Clean the metal.
Gas cylinder empty.
Replace it.
Unsatisfactory gas quality.
Replace it.
Air circulation or wind influence.
Avoid air draughts, protect the welding area.
Gas nozzle is too dirty.
Clean the gas nozzle or replace it.
Bad wire quality.
Use a wire suitable for MIG/MAG welding.
Bad quality of the surface to weld (rust, etc ...)
Clean the workpiece before welding
The gas is not connected
Check that the gas is connected to the machine
input.
Heavy arc splatter.
Arc voltage is too low or too high.
See welding settings.
Bad earth clamp connection.
Check and put the earth clamp as close as possible to
the welding zone.
Insufficient gas protection.
Adjust the gas flow.
No gas at the end of the torch
Bad gas connection.
Check the gas connections
Check that the valve is working properly
Calibration error
An error occurred during the calibration, it is cancel-
led and may be performed again.
Try a new calibration again
Error while downloading
The data on the USB stick is incorrect or corrupted.
Check your data.
Backup error
You have exceeded the maximum number of bac-
kups.
You must delete some lines.
The number of backup jobs is limited to 500.
Automatic deletion of JOBS.
Some of your JOBs has been deleted because they
were incompatible with the new synergies.
-
Push Pull torch detection error
-
Check Push Pull torch connectors
USB key error
No JOB is detected on the USB stick
-
The memory space in the product is full
Free some space on the USB key.
File error
The"..." file does not correspond to the synergies
downloaded into the product
The file was created with synergies which are not
present on the machine.
Battery
The battery seems to be worn out
Change the battery at the back of the HMI.
Fan default.
The fan is not running at the right speed.
Unplug the machine, check it and restart it.
Overvoltage fault
-
Check your electrical installation.
Mains undervoltage failure
-
Check your electrical installation.
Welding start problem
-
Check that the wire flow rate is correct and so is your
electrical installation.
RISK OF INJURY FROM MOVING COMPONENTS
The reels are equipped with moving components that can catch hands, hair, clothing or tools and cause injuries!
• Do not reach for rotating or moving components or drive parts!
• Make sure that all panels remain closed when in use!
• Do not wear gloves when setting up the wire and changing the wire reel.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
