GYS 014657, Manual

Page: 22 / 92

22
PROGYS 220E FV CEL
EN
- The menus are accessible and can be modified. Ex :
- JOB 5, out of adjustment, SAVE IN / JOB 5, the JOB is overwritten with the new parameters and taken into account.
- JOB 5, out of adjustment, SAVE IN / JOB non-existent, it will be taken into account in the current q.L. if and only if this new JOB X is lower than the number
of the JOB entered.
- The JOB reminder is inactive when navigating through the welding cycle or one of the two menus.
(*) A JOB is disturbed by HMI action (welding parameter, JOB recall...), welding is allowed with the new settings. If a JOB recall is performed, then the first
JOB in the series is recalled.
VOLTAGE REDUCING DEVICE (VRD)
The voltage reducing device (or VRD) reduces the assigned no-load voltage to a level not exceeding 35V when the resistance of the external welding circuit
exceeds 200Ω The reaction time is less than 300ms.
By default, the voltage reducer device is disabled. In order to activate it, the user must open the product and follow the following procedure:
- Switch off and disconnect the product from the network
- Set the switches as below:
ON
1 2 3 4
1 2 3 4 VRD
0 0 1 1 NO (by default)
0 0 0 0 YES
Dispswitch
• When the product is switched on, the device is active and the «VRD» LED on the keypad lights up.
REMOTE CONTROL
The remote control operates in TIG mode and in MMA.
F
A
B
C D
E
G
D
C
B
A
045682
045675
ref. 045699 External view Electric diagram according to remote control type.
Connection
1- Plug the remote control into the connection at the back of the machine.
2- The machine will detect automatically the remote control and open a selection menu:
Foot pedal selection.
Remote control with potentiometer selection.
3- The selection of the type of remote control is made using the wheel, the validation is made using the button.
4- The LED (FIG-2, n°14) switches on.
5- It is possible to activate / deactivate the remote control without having to physically unplug the remote control. Press the button , for 3
seconds, the LED (FIG-2, n°14) indicates the state of the remote control (LED on = remote control on).
Connection
The TIG 300 DC is equipped with a female socket for a remote control.
The specific 7 pin male plug (option ref.045699) enables connection to the different types of manual remote control or foot pedal. For the cabling
layout, please see the diagram below.
REMOTE CONTROL TYPE Wire description Pin
Foot pedal Manual remote control
5V A
Cursor B
Common/Earth C
Switch D