Gymrex GR-MG 61, User Manual, Page: 25 / 114

11 – Footrest
12 – Backrest support frame
13 – Backrest
14 – Training handle
a) Place the load arm (9) between arm bracket mounting plates (1). Align the hole
axes. Pass the rotating roller through the hole. Secure the arm on both sides
with bearing washers and M8x25 screws.
b) Insert the load holder (10) into the arm hole axis (9). Secure with an M8 washer
and M8x30 screws. Finally, install the guard.
c) Connect the footrest (11) to the load arm (9). From the inside, insert the
footrest bracket axis into the lower axis of the arm hole. Attach the bottom
fastener with an M8 washer and M8x30 screw, from the outside. Attach the
upper fastener with an M12 washer and M12x20 screws, from the inside.
d) Connect the backrest support frame (12) to the machine frames (1, 3, 5). When
inserting the backrest support frame, align the hole axes. From the top, insert
the training handle (14) into the hole axes, at the contact point of the backrest
bracket (3) and the backrest support frame (12). Connect the resulting
assembly using M12x105 screws and M12 washers. Fix the remaining holes
with M12x75 screws and M12 washers.
e) Place the backrest (13) on the support frame (12). Fasten with M8 washers and
M8x25 screws.
f) Finally, attach the spare load holder to the moving arm bracket (1). Fasten with
M12x30 screws, M12 washers and M12 locknuts. Guide the screw from the
inside.
Fasten using the procedure described in STEP I, item a) (see the drawing).
All connections of the machine should be fixed and pressed correctly. After
completing the assembly activities, it is allowed to start working with the machine.