GYM form SLIM FOLD, Instruction Manual

Page: 10 / 44

10
attaching the base extension (19).
6. Slowly lower the base (3) until it is on
the floor.
7. Firmly tighten the lock screw (7).
Device folding system (see Picture 4)
1. Loosen the lock screw (7).
2. Raise the base to the vertical position
and hold it in place.
3. Attach the base (3) to the vertical
bars (17) using the screw on the vertical
bar (5).
4. Remove the two handlebar screws
(26).
5. Raise the handlebars (6) to the
vertical position. Replace the two
handlebar screws (26) so they are not
lost.
6. When the device is folded, it can be
transported using the wheels (16).
Product Cleaning and Maintenance
• Before performing daily cleaning, make
sure the device is off by pressing the ON/
OFF button and pulling the plug from the
power supply.
• Do not use abrasive products or
solvents to clean the device.
• Remove any dirt from the device with a
damp cloth.
• Use a dry cloth to clean the plug and
control panel. Do not use a damp cloth.
• Do not use the device in very damp or
dusty places that could cause the device
to fail. Set up the device on a flat surface
to prevent it from falling and breaking
down.
• Do not use the device for more than
an hour. Rest for an hour after each one-
hour workout. The components should
be kept clean. Both sides of the belt
should be cleaned to reduce dirt build-
up. Before using the device, make sure
the treadmill surface is clean. Use soap
and a damp cloth to clean the belt. Do not
use solvents. Wipe off the sweat on the
handlebars after each use.
• Anti-static lubricant was applied to the
belt at the factory.
• Lubricant can be applied to the device
after 100 hours of use. Apply a special
treadmill lubricant underneath the
treadmill belt by lifting the belt away
from the base slightly and applying the
lubricant.
Centering the running belt:
IMPORTANT: After continuous use, the
belt may shift to one side due to the
constant pressure of the feet. It should
be centred again by adjusting the belt
screws (29) with the small Allen key
provided (15). See Picture 5:
Check that the belt is centered. IF it is
not, adjust the belt so that it runs freely
(see below).
Check that the running belt is correctly
centered between the end caps every
time before using the treadmill. Adjust
the belt if needed, normally only a small
adjustment is required. Screw half a
turn clockwise on the side that the belt
is too near to, then test for at least 15
seconds at 4km/h (check and adjust a
further quarter or half turn until the belt
is centered)
NOTE: Please check the distance
between the running belt and edge, if it
show as the picture 9 please centered
the belt in the correct way.
Tightening the belt:
1. If the treadmill belt (4) slides during
use, it should be tightened. Switch OFF
the treadmill and unplug it from the power
source. Use the small Allen key (15) to
give the left screws and then the right
screws 1/4 of a turn in the anti-clockwise
direction. Switch ON the main switch and
start the treadmill running at 6 km/h. Walk
on the treadmill. If it still slides, repeat the
process until the belt no longer slides.
- If you do not plan to use the device for
an extended period of time, please store
it in a clean, dry place and prevent it from
coming into contact with dust.
- Do not touch the ON/OFF button or the
power cable with wet hands.
- Do not tug on the cable when
unplugging the device. To prevent the
cable from being damaged, do not place
heavy objects on top of it and do not
wrap it around the device . Do not use
the device if the cable or the plug do not
make a good connection.
NOTE: the running surface belt should
not be tightened too hard as this can
cause noise and damage the machine
Techn
ical Specifications:
Voltage: 220-240V
Frequency: 50/60 Hz
Power: 500 W
Comply with Normatives:
BS EN ISO 20957-1: 2013
BS EN 957-6:2010+A1:2014
Unfolded Measurements
1358 mm x 610 mm x 1175 mm (L x W
x H)
Folded Measurements
535 mm x 610 mm x 1435 mm (L x W x H)
Packaging Measurements
1360mm x 280mm x 650mm (L x W x H)
Gross Weight 27,5 kg
Net Weight 24.5 kg
Class HC product for household use
Gymform Slim Fold Treadmill
(VDPGYCIND0124)
Disposal of materials
A symbol of a crossed-out wheeled
bin means you should find out about
and follow local regulations about
disposing of this kind of product.
Do not dispose of this product as you
would other household waste. Dispose
of this device in accordance with
the corresponding local regulations.
Electrical and electronic devices contain
hazardous substances that can have
harmful effects on the environment and/
or human health and should be recycled
properly.
Quality Warranty:
This product is covered by a warranty
against manufacturing defects subject
to the time periods stipulated by the
legislation in force in each country.