Guzzanti GZ 750 QUATRO, Installation, Maintenance And Usage

Page: 28 / 29

8
Electrical connection
The mains power supply must correspond to the rating indicated on the plate situated inside the
hood. If provided with a plug connect the hood to a socket in compliance with current regulations and
positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection)
or if the plug is not located in an accessible area, after installation, apply a double pole switch in
accordance with standards which assures the complete disconnection of the mains under conditions
relating to over-current category III, in accordance with installation instructions.
Warning ! Before re-connecting the hood circuit to the mains supply and checking the efficient function,
always check that the mains cable is correctly assembled. The hood is provided with a special power
cable; if the cable is damaged, request a new one from Technical Service.
Mounting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a
qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling.
The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this
appliance to the wall. Surface mounting only.
Operation
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the
cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during
cooking and for another 15 minutes approximately after terminating cooking..
1 OFF motor
Pressing the button during functioning, the hood turns OFF.
2 Speed Increase
Pressing the button the hood passes from the OFF state to speed 1.
Pressing the button (hood in ON state) the motor speed is increased from speed 1 to intensive.
To each speed corresponds the ignition of the respective led.
Speed 1: 1
Speed 2: 2
Speed 3: 3
Speed 4: 4
3 ON/OFF lights
4 Speed timing
5 Function state indicator
Speed Timing
Kitchen extractor hood is equipped with the option of programming automatic switch-off of the hood
fan in 10-minute intervals, up to maximum delay of 60 minutes. Timer” is actuated by pressing „T”
button during operation of the hood with the required fan speed.